1.5A 2-Way MX1508 Dual Channel DC Motor Driver PWM Speed Dual H-Bridge Stepper
Description:
Motor drive module is ideal for use in battery-powered smart car, toy cars, robots. Supply voltage 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepper motors ,can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed. Each can provide continuous current of 1.5A, peak current up to 2.5A, thermal protection and can be automatically restored.
Product Highlights:
Use of imported original chip, built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption; ideal for battery powered p[rojects
Dual Channel 1.5A x 2 output - MAX current to be limited to 2.5A
Built-in thermal protection circuit - automatic recovery after the temperature lowers
Small size; light weight; 0 standby current makes it the ideal choice for your maker project
Product parameters:
Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor.
The module supply voltage 2V-10V.
Signal input voltage 1.8-7V.
Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
Product Size: 2.47cm x 2.1cm x 5mm (length, width, height), ultra-small size.
1.5A 2-Way MX1508 Dual Channel DC Motor Driver PWM Speed Dual H-Bridge Stepper
Description:
Motor drive module is ideal for use in battery-powered smart car, toy cars, robots. Supply voltage 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepper motors ,can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed. Each can provide continuous current of 1.5A, peak current up to 2.5A, thermal protection and can be automatically restored.
Product Highlights:
Use of imported original chip, built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption; ideal for battery powered p[rojects
Dual Channel 1.5A x 2 output - MAX current to be limited to 2.5A
Built-in thermal protection circuit - automatic recovery after the temperature lowers
Small size; light weight; 0 standby current makes it the ideal choice for your maker project
Product parameters:
Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor.
The module supply voltage 2V-10V.
Signal input voltage 1.8-7V.
Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
Product Size: 2.47cm x 2.1cm x 5mm (length, width, height), ultra-small size.