This is a WS2812 or WS2812B (Addressable / Neopixels) RGB LED controller based on the ESP-01 / ESP-01S. With this board, your will easy to make your colorful LED Strip project.

• Can be used INSTEAD of a Quinled Dig-Uno. Note: The Quinled Dig-Uno is highly reccomended; although this product will work in it's place. Don't forget to purchase the ESP-01S chip also.
• This is a breakout board compatible with ESP01-01S Microcontrollers (not included)
• Wire Interface: 3Pin PH2.0 for WS2812/addressable LED strips (5v)
• Working voltage:DC 3.7V-5V
• Support 3.7V Lipo battery operation
• This breakout board does not support analog (R/G/B/WW/CW) strips.
• Perfect circuit for WLED LED controller software, by Aircookie. (https://github.com/Aircoookie/WLED )

Note: Aircoookie has put a lot of time and effort into his project. Please consider donating to him via his GitHub if you use his software.

WWW.XGEEKS.CA is in no-way affiliated with Aircoookie or WLED. ( We just, really, really, REALLY appreciate his awesome software!)

• Supports all other Arduino, custom codes and Sketches when correctly written and coded.

Instructions:

Pre-program the ESP01/01S controller using your preferred USB->FTDI adaptor, Arduino or other method.

Insert the ESP01-01S in to the breakout board. Power the breakout board using 2.54 mm headers from a suitable power source.

( GND must be common with powersupply and LED strip )